LAB Gruppen FAD1202

- 2 x 120 Watt amplifier for commercial and industrial applications
- Low-Z (4/8 Ohm) and High-Z (70/100 V) operation per output with switchable high-pass filter
- Direct drive, constant power technology for superior audio performance and reliability
- Dante * audio connectivity to enable creating large audio systems over a local network
- Energy Star * certified design conserves energy and drastically reduces operational cost
- GPI remote volume control using standard RJ-45 connector and Ethernet cable
- Auto Ramp circuitry for quiet and fast power up/down enables real-world energy savings
- Tamperproof gain controls for each channel on rear panel location
- Rack-mountable 1U, half-rack width enclosure with joining brackets for rack, table and wall mounting
- Euroblock type amplifier output connectors
- Convection-cooled, fan-less amplifier technology for low noise

- Hmotnost: 2.600kg
- Výška: 44mm
- Šířka: 218mm
- Hloubka: 280mm

Maximum Output Power:
- 4 or 8 Ω per channel: 120 W
- Number of Ouput Channels: 2
Minimun Load Impedance:
- 4 Ω mode: 4 Ω
- 8 Ω mode: 8 Ω
- 70 V output mode: 41 Ω
- 100 V output mode: 82 Ω
Controls:
- Front: N/A
- Rear: Gain control, load config (4 Ω / 8 Ω / 70 V / 100 V), high-pass filter switch, reset button)
Indicators:
- Power: On (blue), standby (yellow)
- Limit (red LED), per channel: -1.5 dBFS (digital)
- Signal (green LED), per channel: > -63 dBFS (digital)
- Fault (red LED): Overheat, DC fault, over current etc
- Dante: Indentify (yellow), clock sync (white)
System:
Input Transmission Type: Dante, 2 channels Rx
- Input Connectivity: 1 x RJ45 Ethernet connector, 1-port 100 Mbps to Dante interface
- Input Sensitivity: -2 dBFS (digital)
- Maximum input level: 0 dBFS (digital)
- Outputs: 1 x 4-pin 5.08 mm Euroblock connector
- Output circuit type: Class D
- Remote connector: 2 x RJ45 Ethernet connector
Performance:
- Distortion, 1/8 rated power: <0.1%
- Frequency response: 20 Hz to 20 kHz, +0 / -1.5 dB
- Crosstalk: >72 dB
- Signal-to-noise: >101 dBA
- High-pass filter: 80 Hz HPF
Circuit Protection:
- Cooling: Convection-cooled, fanless
- Amplifier protection: Thermal protection, over current protection, DC protection, high frequency protection
- Load protection: Controlled start and shutdown behaviour, DC-fault protection
Power Supply, Voltage (Fuse):
- Main voltage: 100-240 V~, 50/60 Hz with active power factor correction
- Power consumption 1/8th rated power @ 4 Ω: 70 W
- Mains connector: Standard IEC connector
- Dimensions (H x W x D): 44 x 218 x 280 mm (1.7 x 8.6 x 11.0")
- Weight: 2.6 kg (5.7 lbs)
- Finish: Brushed black anodized aluminum chassis with black painted steel bottom
- Approvals: CE, WEEE, CCC, cTUVus, PSE, RCM, RoHS, FCC part 15 Class B, Energy Star 3.0