Shure KSM11/B (Black)

A25E mic clip and carrying case

- Proprietary condenser capsule utilizing a ¾” gold diaphragm and premium electronics for exceptional dynamic range and transient response.
- Highly consistent, deep cardioid polar pattern reduces off-axis phase distortion for pristinely focused vocal reproduction to provide rich and full low frequency response, linear and transparent mid-range and natural high-end detail.
- Streamlined design for an overall smaller and lighter capsule footprint.
- Advanced suspended isolation system for virtually zero handling noise.
- Dent-resistant hardened steel grille with 3-stage plosive reduction pop filtering for consistent, artifact-free vocals.
- Also available separately as black and nickel wireless capsules (RPW192 and RPW194), and with ULX-D transmitters in black and Axient Digital transmitters in black and nickel. RPW192 and RPW194 are compatible with all Shure handheld transmitters with interchangeable microphone capsules.

- Type: Electret Condenser
- Polar Pattern: Cardioid
- Freqeuncy Response: 80 Hz to 20 kHz
- Output Impedance(1 kHz): 150 Ω
Sensitivity at 1 kHz, open circuit voltage:
1k load: –49 dBV/Pa (3.5 mV)
5k load: -48 dBV/Pa (3.9 mV)
1 Pa=94 dB SPL
Maximum SPL with 5 VDC: 149 dB SPL
Signal-to-Noise Ratio:
75 dB
S/N ratio is the difference between 94 dB SPL and equivalent
SPL of self noise, A-weighted
Dynamic Range with 5 VDC:
1k load: 130 dB
5k load: 131 dB
Clipping Level with 5 VDC:
1k load: 6.2 dBV
5k load: 7.7 dBV
Self Noise:
19 dB SPL
typical, equivalent SPL, A-weighted
- Common Mode Rejection: > 55 dB
- Connector: Three-pin professional audio (XLR), male, balanced
- Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3
- Power Requirements: 11 to 52 V DC phantom power (IEC-61938) 5.2 mA, maximum
- Weight: 239 g (8.43 oz.)
- Dimensions (Dia × Height): 1.92 × 3.0 in. (48.7 × 76.3 mm)
- Housing: Aluminum and steel grille