DPA ST4011A

Microphones Set

EUR 3915.70

Incl. VAT, free shipping

Product #	160765
Brand	DPA
Category	Microphones Sets
Brand Category	DPA - Mic Sets
Series	DPA d:dicate
Release date	April 2013
Availability	Will be ordered for you as quick as possible

Add to wishlist

World-wide cardioid reference mic

4011A cardioids are exceptionally linear in their frequency response - also off axis, giving you the natural experience.

Be the first to write a review for this product

Description
Attributes
Properties
Brand

Description

They handle extremely high SPL and will therefore allow for close placement and are often used for piano recordings with a placement closer to the hammers or as overheads for drums.

The DPA ST4011A is a complete DPA 4011A Stereo Pair with two carefully factory-matched first order cardioid microphones. Even though the standard tolerances on DPA Reference Standards are extremely low, a stereo match is even closer.

The specially selected DPA 4011A microphones are matched within ±1 dB on both frequency response and sensitivity.

The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory inlay.

Attributes

Product Details

Product Number	160765
Brand	Danish Pro Audio
Series	d:dicate
Category	Microphones Set
Brand Category	DPA - Mic Sets
Relevancy rank	28 of 33
Date	April 2013

Properties

- World-wide cardioid reference mic
- Handles very high sound pressure levels
- Carefully matched within ±1 dB
- PeliTM Case transportation and protection

Directional pattern: Cardioid
Principle of operation: Pressure gradient
Cartridge type: Pre-polarized condenser
Frequency range: 20 Hz - 20 kHz
Frequency range, ± 2 dB, at 30 cm: 40 Hz - 20 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB (correct with the attenuator in 0 dB or -20 dB setting)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 76 dB(A)
Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
Dynamic range: Typ. 121 dB
Max. SPL, peak before clipping: 159 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black
Weight: 158 g (5.6 oz)
Microphone diameter: 19 mm (0.75 in)
Capsule diameter: 19 mm (0.75 in)
Microphone length: 170 mm (6.7 in)
Output voltage, RMS: > 5 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH): Up to 90%
Matching tolerance: ± 1 dB
Phase deviation for kit: < 10°

Included in this kit

Two carefully matched 4011A cardioid microphones, sturdy PeliTM case, holders, and windscreens.

Brand

Unparalleled accuracy Close your eyes and listen. From the subtlest nuances of a solo violin or vocalist to the thunderous intensity of a full brass section or drum kit, it's all there, spectacularly pure and uncolored. The sound is so crisp and detailed that you begin to create a mental picture of what the recording environment looked like. The microphones responsible? DPA, of course. From B&K to DPA Although DPA has technically only been in existence since 1992, our company draws on more than five decades of world-class microphone design experience going back to the first range of measurement microphones created by our progenitor, Brüel & Kjær, in the 1950s. Rapid growth and rabid fans Over the past 16 years, we have expanded from a tiny initial staff of only two people to well over 100 and are now represented by professional audio distributors and dealers in more than 40 countries around the world. In the past five years alone, we have experienced an average annual growth of 25 percent, and, in 2007, were presented with the prestigious King Frederik IX's award for outstanding contribution to Danish export. What's our secret? The reason for our success is simple: DPA's ultimate goal is to provide you - whether you're in live sound, recording, theater or broadcast - with the absolute finest possible microphone solutions for your tasks. We take no shortcuts in our design processes nor make any compromises in our manufacturing, which is all done in Denmark. As a result, our products are globally praised for their exceptional clarity and transparency, superb specifications, supreme reliability and, above all, pure, uncolored and undistorted sound.

Report incorrect data about this product