Walrus Audio Fundamental Series - Drive
Distortion Pedal
CHF 89.90
MSRP: CHF 103.20
MSRP: CHF 103.20
Free delivery (CH)
Product # | 243881 |
Brand | Walrus Audio![]() |
Category | Distortion Pedals | Brand Category | Walrus Audio - Distortion |
Series | Walrus Audio Fundamental |
Release date | April 2023 |
Availability | ![]() |
Shop | Availability |
---|---|
Giebenach BL | ![]() |
Attributes
Key attributes
| ||||||||||||||
Distortion Pedal attributes
| ||||||||||||||
Product Details
|
Properties
- Gain – The Gain slider sets the amount of gain applied to your guitar signal passing through the overdrive circuit.
- Tone – The Tone slider controls the amount of high-frequency level reduction
- Volume – The Volume slider sets the overall output volume of the pedal.
- Slide Switch – The slide switch allows you to change between 3 distinct flavors of the pedal. Each position has different clipping modes or tone profiles.
- Smooth - A classic soft clipping silicon overdrive. Clean and smooth
- Crunch - Silicon soft clipping with added hard clipping silicon diodes and a slight low end boost. Crunchy and edgy
- Bright - Silicon soft and hard clipping from the Crunch mode with a pre-clipping low end cut. Bright and glassy
- Bypass Switch – Turns the effect on and off.
- Bypass LED - Illuminated when the effect is engaged.
- Input Jack - 1/4 inch cable from instrument.
- Output Jack - 1/4 inch cable to amplifier.
- 9v Jack – 9-volt DC, Center Negative, 100mA min.
- Tone – The Tone slider controls the amount of high-frequency level reduction
- Volume – The Volume slider sets the overall output volume of the pedal.
- Slide Switch – The slide switch allows you to change between 3 distinct flavors of the pedal. Each position has different clipping modes or tone profiles.
- Smooth - A classic soft clipping silicon overdrive. Clean and smooth
- Crunch - Silicon soft clipping with added hard clipping silicon diodes and a slight low end boost. Crunchy and edgy
- Bright - Silicon soft and hard clipping from the Crunch mode with a pre-clipping low end cut. Bright and glassy
- Bypass Switch – Turns the effect on and off.
- Bypass LED - Illuminated when the effect is engaged.
- Input Jack - 1/4 inch cable from instrument.
- Output Jack - 1/4 inch cable to amplifier.
- 9v Jack – 9-volt DC, Center Negative, 100mA min.
Series Info

Brand
Report incorrect data about this product
Recommended accessories
BlackLine DC0103AA (15cm)
CHF 8.95