Yamaha TF Rack

- Mixing Capacity Input Channels 40 (32 mono + 2 stereo + 2 return)
- Aux Buses 20 (8 mono + 6 stereo)
- Stereo Buses 1
- Sub Buses 1
- Input channel functions 8 DCA Groups
- I/O Inputs 16 mic/line (XLR/TRS combo) + 1 stereo line (RCA pin)
- Outputs 16 (8 XLR + 8 TRS phone)
- Expansion slots 1 (for NY64-D)
- On-board processors DSP 8 Effects + 10 GEQ
- General specifications TF-RACK
- Sampling frequency rate Internal 48 kHz
- Signal delay Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz
- Fader Resolution = 10-bit, +10 dB to -138 dB, -? dB all faders
- Total harmonic distortion Less than 0.05% 20 Hz-20 kHz @+4 dBu into 600 [Ohm], INPUT to OMNI OUT, Input Gain=Min. (Measured with a -18 dB/octave filter@80 kHz)
- Frequency response +0.5, -1.5 dB 20 Hz-20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT
- Dynamic range 110 dB typ., DA Converter, 108 dB typ., INPUT to OMNI OUT, Input Gain=Min.
- Hum & noise level Equivalent input noise -128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter)
- Residual output noise -85 dBu, ST master off (Measured with an A-Weight filter)
- Crosstalk -100 dB (Measured with a -30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min.
- Power requirements 100-240 V 50/60 Hz
- Power consumption 85 W
- Dimensions W 480 mm (18-7/8 in)
- H 132 mm (5-1/4 in)
- D 409 mm (16-1/8 in)
- Net weight 9.2 kg (20.3lb)
- Accessories Quick Guide, Power Cord NUENDO LIVE (DAW Software), Rubber stoppers(4)
- Options Audio Interface Card (NY-64D), Foot Switch (FC5)
- Others Operating temperature range: 0-40 °C, Storage temperature range: -20-60 °C
Recording/ Playback
- PC/Mac (USB2.0) Recording 34 tracks, Playback 34 tracks
- USB Storage Device Recording 2 tracks (USB hard drive/ SSD)*, Playback 2 tracks (USB hard drive/ SSD/ thumb drive)
Please note - USB thumb drives are not supported by TF for recording purposes. Please refer to this link for compatible hard drives.
- Analog input characteristics
- Input Terminals GAIN Load
- Impedance For Use With
- Nominal Input Level Connector balanced /
- Unbalanced
- Sensitivity*1 Nominal Max. before clip
- INPUT1-16 +66dB 7.5K[Ohm]
- 50-600[Ohm] Mics
- or 600[Ohm] Lines
- 82dBu (61.6?V) -62dBu (0.616mV) -42dBu (6.16mV) Combo Jack (XLR-3-31 type *2
- or TRS phone *3) Balanced
- 6dB -10dBu (245mV) +10dBu (2.45V) +30dBu (24.5V)
- ST IN - 10k[Ohm] 600[Ohm] Lines -30dBV (31.6?V) -10dBV (316mV) +10dBV (3.16V) RCA Pin Jack Unbalanced
1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
- 2. 1: GND, 2: HOT, 3: COLD
- 3. Tip: HOT, Ring: COLD, Sleeve: GND
- 4. In these specifications, 0dBu = 0.775Vrms.
- 5. +48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.
- Analog output characteristics
- Output Terminals Source
- Impedance For Use With
- Nominal Output Level Connector balanced /
- Unbalanced
- Nominal Max. before clip
- OMNI OUT 1-8 75[Ohm] 600[Ohm] Lines
- +4dBu (1.23 V) +24dBu (12.3 V) XLR-3-32 type *1 Balanced
- OMNI OUT 9-16 TRS Phone Jack *6
- PHONES *5 100[Ohm] 40[Ohm] Phones 3mW 75mW Stereo Phone Jack (TRS) *2 Unbalanced
1. 1: GND, 2: HOT, 3: COLD
- 2. Tip: LEFT, Ring: RIGHT, Sleeve: GND
- 3. In these specifications, 0dBu = 0.775Vrms.
- 4. All output DA converters are 24bit, 128times oversampling.
- 5. The position of the level control is lowered by 16dB from the maximum.
- 6. Tip: HOT, Ring: COLD, Sleeve: GND
- Digital input/output specifications
- Terminals Format Data length Audio Connector
- USB (TO HOST) USB 24bit 34ch input / 34ch output, PCM USB (B type)
- iPad USB - Playback: MP3 or WAV file data / Record: WAV file data
- USB (A type)
- Control I/O specifications
- Terminals Format Level Connector
- NETWORK IEEE802.3 10BASE-T/100Base-TX RJ-45
- FOOT SW - - TS Phone

- Weight: 9.930kg
- Height: 220mm
- Width: 520mm
- Depth: 580mm